|Ready and working normally
|Use the Fluent app or Alarm.com website to choose a custom color in place of default green.
|In Call mode
|A call has been initiated or is occurring.
|Please wait while the doorbell is booting up.
|Battery is charging
|Battery may charge for ~30 minutes after installation.
|Blue | Green Alternating Flash
|Connected to Wi-Fi, waiting for server connection
|Blue | Yellow Alternating Flash
|Firmware update in progress
|Orange Rapid Double Flash
|No Wi-Fi connectivity
|Check your Internet connection. Your Wi-Fi credentials may have changed. Enter Wi-Fi Access Point Mode (see Troubleshooting) and re-add the doorbell camera using the app.
|Blue Rapid Double Flash
|Power supply issue
|Contact your installer. The doorbell transformer may need to be replaced
|No Color | Off
|Possible power supply issue
|If the LED on the Doorbell Camera is not showing any color, there may be a power issue or the LED may have been turned down in the Video Settings on the Alarm.com website.
|Entering Troubleshooting modes
|Continue to press & hold for troubleshooting steps below.
|Red | Green Alternating Flash
|Wi-Fi Access Point mode
|Connect to the camera’s temporary network and use the app to re-add the camera. Push & hold ~60 sec until flashing, then release.
|Reboots the camera. Push & hold ~70 sec until flashing, then release.
|Factory resets the camera. Deletes all Wi-Fi and configuration information. Push & hold ~80 sec until flashing, then release.