What is Needed
1 – Small Phillips-head Screwdriver
1 – CR-2450 Battery
Instructions
- Open the sensor by removing the rubber tabs on the bottom and the screws beneath them.
- Remove the old battery.
- Wait 15–20 seconds.
- Replace with a CR-2450 battery.
- Fully close the sensor and replace the screws and rubber tabs.
Test the Sensor
- User code needed -
- To test the sensor take a wet paper towel and place the sensor on it and ensure the 4 prongs touch the wet towel.
- Disarm the panel with 4 digit code